Naman Daxina

firstly i connected LED and using resistor but i ended up with fusing 2 LEDs and then i got to know resistor was not working properly and then after replacing it worked

First i connected 4 leds same as last challenge and in code i changed the delay time and it worked

First I connected four Leds as same as previous challenges And then pasted code and it worked

Firstly connected all LEDs according pin defined in code then it worked according to code

Firstly i connected six LEDs as same as previous challenge then it worked like first one led blinks and then other LEDs also start blinking

Firstly connected 6 LEDs according to pins defined in code then after uploading code it worked

Firstly connected 4 LEDs then in code the pins were 8,9,10,11 so connected pins according to that and it worked

I connected 8 LEDs with breadboard i faced problems in connecting multiple LEDs and then learned how to connect by analysing previous connections and then it worked, all LEDs were glowing 1 by 1

first i connected four leds with arduino upload the code for the pin 8,9,10,11 and it worked as 4 leds were working one by one

First i done connection according to previous challenge then i pasted the code and it worked

first learned how to connect LEDs with resistors then i pated the code and it worked

Done connections according to previous challenge and then in code changed delay 1 = 500, delay 2 = 1000

Connection done according to previous challenges Made change in code like delay 1=3000 and delay 2=1000

I took 2 L and connected them according to last challenges and then changed the delay section changed it to 500 due to which speed increased

Learned how to slow down the speed of blinking First i pasted the code and change the delay section changed it 2000

Learned how to blink 8 LEDs on Breadboard

Learned how to connect 5 LEDs and how current flows horizontally

learned how to connect four LEDs in breadboard and make them blink

learned how current flows from one led to second led

learned how current flows in breadboard BLINKED led on breadboard

I learned how to blink led on arduino board